RS485 bus basic characteristics
Based on RS485 bus industry standards, RS485 bus industry for the characteristic impedance of 120 Ω half duplex communication bus, RS - 485 bus general maximum support 32 nodes (including main control device and control device).
1, the RS485 bus transmission distance
When using 0.56 mm (24 awg) twisted pair as a communication cable, according to different baud rate, the maximum transmission distance theoretical value in table 2-1:
波特率 |
最大传输距离 |
2400 Bps |
1800米 |
4800 Bps |
1200米 |
9600 Bps |
800米 |
表2-1
2、连接方式与终端电阻
a) RS485工业总线标准要求各设备之间采用菊花链式连接方式,两头必须接有120Ω终端电阻。如图3-1
图3-1
简化连接可采用下图,但“D”段距离不得超过7 米。
图3-2
b) 设备终端120Ω电阻的连接方式:设备终端电阻120Ω电阻在控制电路板上已备有,共有两种连接方式.出厂时设置为缺省连接方式,此时控制电路板上的跳线帽插接在2~3插座位置上,这时120Ω电阻未接入。当需要接入120Ω电阻时,要将图中的控制电路上面的跳线帽从2~3位置拔下来,然后插接在1~2位置。这样120Ω电阻接入电路中。
3、实际使用中的问题
实际施工使用中用户常采用星形链接方式,此时终端电阻必须连接在线路距离最远的两个设备上(如图4-1)中1 #与15 #设备,但是由于该连接方式不符合RS485 工业标准的使用要求,因此在各设备线路距离较远时,容易产生信号反射、抗干扰能力下降等问题,导致控制信号的可靠性下降。反映现象为机器完全或间断不受控制或自行运转无法停止。对于这种情况建议采用RS485分配器。该产品可以有效地将星形连接转换为符合RS485工业标准所规定的连接方式,从而避免产生问题,提高通信可靠性。(如图4-2)
Copyright © 2007 - 2014 Shandong Feiyue Electronics Technology Co.,Ltd . All Rights Reserved.
Add:No.2379 Keyuan Road,Hi-tech Zone,Jinan city,China
Tel:86-0531-88681507 Fax:86-0531-88682032 Phone:+86-13656408264